Solar Power Kit for Cabin - Off-Grid System for A Small House

This package includes everything you’ll need to go solar for a cabin or small house short of common electrical components either you or your installer can get at your local hardware store.  This system is perfect for running a few lights, TV and the occasional appliance or water pump. This system is also fully expandable and can handle up to 1600 watts of solar modules and a large battery bank if needed.

230 (DC watt) Off Grid Cabin Package $ 6,890.00

Start with 2 high quality BP 3115J Solar Modules 115 watts each

Midnight power panel features:

• Pre-wired to save time and money. All field wiring connections are clearly labeled
   
• Easily expands to accommodate additional inverters
   
• Six slots for din rail breakers, PV, Wind, Hydro, AC distribution
   
• 500 amp 50 mv shunt for battery status monitoring systems
   
• Pre-wired 50 amp 240 VAC inverter AC bypass switch
   
• Pre-wired 50 amp 240 VAC AC Input disconnect
   
• Bus bars for battery plus, battery minus and ground
   
• Mounting hardware for inverter and charge controller
   
• Snap in plastic conduit for AC, Mate and RTS wires
   
• Mounting brackets for hanging E-Panel on wall
   
• Heavy duty 175 amp AC distribution block
   
• Cutouts for two GFCI outlets
   
• DC Inverter battery breaker
   
• Internal inverter cables

Outback Inverter features:

1. Built to survive dust, bugs, even rain and salt air. Choice of sealed FX or bug-proof VFX
    
2. Smooth, true sinewave AC output waveform
    
3. Systems can grow with your needs - up to ten inverter/chargers can be stacked
    
4. Advanced charging algorithms provide fast recharging while increase battery life

Included is the versatile Outback MX60 Charge Controller:

1. The MX60 is on the cutting edge of charge controller design.
    
2. Maximum Power Point Tracking (MPPT)
    
3. A peak operating efficiency of 98% maximizes your PV array’s performance.
    
4. The MX60’s wide DC input range and 60 amp DC output current rating for 12, 24 or 48 VDC systems provides flexibility in the wiring as well as the sizing of your solar array.
    
5. The ability to step-down a high voltage solar array to a low voltage battery can save you money by reducing the size of wire required and making the installation simpler and faster.
6. 
    
7. We also include the OutBack MATE; this is a complete system controller and display. It provides a display of the operation as well as allows control and adjustment of the set points. The OutBack Mate can be mounted in any location allowing monitoring and control from inside the home.

The balance of the system components included with this package are:

• (4) Deka L16 370 AHr deep cycle batteries - 6V flooded
• (2) 63A 125VDC din rail-mounted breaker
• (1) 50 amp AC din rail mounted breaker
• (2) 10-foot, 4/0 inverter to battery cables
• (3) 2/0 Pre-made battery cables - 20"
• (2) Grounding lug, tin-plated copper, outdoor rated
• With just two modules we did not include a racking system. We can add a ground mount tilt up rack for $350.00 or many customers choose to make their own.

Note that we can add, eliminate or switch any of the components listed.

Need more information or want a different package for your cabin?  Request a quote.

Top